CAN COMMUNICATION SYSTEM (for LHD) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.CHECK AND CLEAR DTCS |
| |||||
| 2.CHECK FOR INSTALLED SYSTEMS (ECUS & SENSORS) THAT ADOPT CAN COMMUNICATION |
Based on the vehicle equipment and specifications, confirm the systems that use CAN communication (Click here).
| |||||
| 3.CHECK CAN NO. 1 BUS WIRE |
Check the CAN No. 1 bus wire (Click here).
| |||||
| 4.CHECK WITH INTELLIGENT TESTER |
Using the intelligent tester, display the "Communication Bus Check" screen (Click here).
Observe the screen for approximately 1 minute to check the ECUs and sensors displayed on the screen.
| Symptom | Proceed to |
| All ECUs and sensors connected to the CAN communication system are displayed on the screen. (CAN bus circuit is currently normal) | A |
| Some of the ECUs and sensors connected to the CAN communication system are not displayed on the screen. (Open in ECU or sensor branch wires, or communication interrupted) | B*1 |
| Some of the ECUs and sensors connected to the CAN communication system are not displayed on the screen. During this check, some ECUs and sensors repeatedly appear and disappear from the screen. (Open in one side of ECU or sensor branch wires) | C |
| D |
| All ECUs and sensors connected to the CAN MS bus are not displayed on the screen. (Open in main body ECU branch wire) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| |||||
| 5.RECHECK DTC |
| Result | Proceed to |
| An ECU connected to the CAN No. 1 bus outputs a communication error DTC. (A malfunction occurred in the CAN No. 1 bus) | A |
| The main body ECU outputs CAN MS bus DTC B2326. (A malfunction occurred in the CAN MS bus) | B |
| The main body ECU outputs DTCs other than CAN MS bus DTC B2326. (A malfunction occurred in an ECU branch wire connected to the CAN MS bus) | C |
|
| ||||
|
| ||||
| |||||
| 6.DTC COMBINATION TABLE |
Confirm trouble according to the combination of output DTCs regarding the CAN communication system (Click here).
| |||||
| 7.CIRCUIT INSPECTION |
| |||||
| 8.IDENTIFICATION OF PROBLEM |
| |||||
| 9.REPAIR OR REPLACE |
| |||||
| 10.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|