CAN COMMUNICATION SYSTEM (for LHD) > CAN Bus Line |

| 1.CHECK CAN BUS WIRE (MAIN BUS WIRE FOR DISCONNECTION, BUS WIRES FOR SHORT CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value | Result |
| E10-6 (CANH) - E10-14 (CANL) | Ignition switch off | 54 to 69 Ω | OK |
| Result | Proceed to |
| OK | A |
| 70 Ω or higher | B |
| Below 54 Ω | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK CAN BUS WIRE (SHORT TO GND IN CAN BUS WIRE) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| E10-4 (CG) - E10-6 (CANH) | Ignition switch off | 200 Ω or higher |
| E10-4 (CG) - E10-14 (CANL) | Ignition switch off | 200 Ω or higher |
|
| ||||
| OK | |
| 3.CHECK CAN BUS WIRE (SHORT TO B+ IN CAN BUS WIRE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| E10-6 (CANH) - E10-16 (BAT) | Cable disconnected from negative (-) battery terminal | 6 kΩ or higher |
| E10-14 (CANL) - E10-16 (BAT) | Cable disconnected from negative (-) battery terminal | 6 kΩ or higher |
|
| ||||
| OK | ||
| ||