CAN COMMUNICATION SYSTEM (for LHD) > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode |
|
|


| 1.CHECK CAN BUS LINE FOR DISCONNECTION (ECM MAIN BUS WIRE) |
![]() |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| A24-38 (CANH) - A24-46 (CANL) | Ignition switch off | 108 to 132 Ω |
| Tester Connection | Condition | Specified Value |
| A55-38 (CANH) - A55-46 (CANL) | Ignition switch off | 108 to 132 Ω |
|
| ||||
| OK | |
| 2.CHECK ECM POWER SOURCE CIRCUIT |
Check the ECM power source circuit (2AZ-FE: Click hereor 2GR-FE: Click here).
|
| ||||
| OK | ||
| ||