DTC C0278/11 Open in ABS Solenoid Relay Circuit |
DTC C0279/12 Short to B+ in ABS Solenoid Relay Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C0278/11 | When any of the following (1 or 2) is detected: 1. Both of the following conditions continue for 0.2 seconds or more.
|
|
| C0279/12 | Immediately after the ignition switch is turned on (IG), the solenoid relay contact is closed for 0.2 seconds or more when the relay is turned off. | Brake actuator assembly |

| 1.INSPECT ABS NO. 2 FUSE |
![]() |
Remove the fusible link from the engine room R/B.
![]() |
Check if the fusible link is melted.
Install the fusible link to the engine room R/B with the nut.
|
| ||||
| OK | |
| 2.INSPECT SKID CONTROL ECU (+BS TERMINAL) |
![]() |
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-31 (+BS) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU (GND TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-32 (GND1) - Body ground | Always | Below 1 Ω |
| A26-1 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Reconnect the skid control ECU connector.
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at the speed of 4 mph (6 km/h) or more.
Check if the same DTC is recorded (Click here).
| Condition | Proceed to |
| DTCs (C0278/11 and/or C0279/12) are not output | A |
| DTCs (C0278/11 and/or C0279/12) are output | B |
|
| ||||
| A | ||
| ||