DTC C1251/51 Open in Pump Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1251/51 |
|
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS MOTOR RELAY) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Active Test mode on the intelligent tester.
| Item (Display) | Vehicle Condition / Test Details | Diagnostic Note |
| Motor Relay | Turns ABS motor relay ON / OFF | Operating sound of relay (clicking sound) and motor can be heard |
Check the operating sound of the ABS motor relay and motor when operating it with the intelligent tester.
|
| ||||
| NG | |
| 2.INSPECT SKID CONTROL ECU (GND2 TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-1 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Reconnect the skid control ECU connector.
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at the speed of 4.3 mph (7 km/h) or more.
Check if the same DTC is recorded (Click here).
| Condition | Proceed to |
| DTC (C1251/51) is not output | A |
| DTC (C1251/51) is output | B |
|
| ||||
| A | ||
| ||