DTC C1210/36 Zero Point Calibration of Yaw Rate Sensor Undone |
DTC C1336/39 Zero Point Calibration of Acceleration Sensor Undone |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1210/36 | Zero point calibration of yaw rate sensor undone. |
|
| C1336/39 | When either of the following is detected:
|
|
| 1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR |
Perform zero point calibration of the yaw rate and acceleration sensor (Click here).
| NEXT | |
| 2.RECONFIRM DTC |
Clear the DTC (Click here).
Check if the same DTCs are recorded (Click here).
| Condition | Proceed to |
| DTCs (C1210/36 and/or C1336/39) are output | A |
| DTCs (C1210/36 and/or C1336/39) are not output | B |
|
| ||||
| A | |
| 3.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and acceleration sensor has been installed properly (Click here).
|
| ||||
| OK | ||
| ||