VEHICLE STABILITY CONTROL SYSTEM > Skid Control Buzzer Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SKID CONTROL BUZZER) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Active Test mode on the intelligent tester.
| Item (Display) | Vehicle Condition / Test Details | Diagnostic Note |
| Buzzer | Turns skid control buzzer ON / OFF | Buzzer can be heard |
Check that the buzzer sounds/stops when turning the skid control buzzer on/off by using the intelligent tester.
| Condition | Proceed to |
| Buzzer does not sound or sounds constantly | A |
| Buzzer sounds/stops | B |
|
| ||||
| A | |
| 2.INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control buzzer connector.
Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E13-2 - Body ground | Ignition switch on (IG) | 10 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL BUZZER |
![]() |
Apply battery negative voltage to terminal 1, and battery positive voltage to terminal 2 of the skid control buzzer, and then check that the buzzer sounds.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - SKID CONTROL BUZZER) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-30 (BZ) - E13-1 | Always | Below 1 Ω |
| A26-30 (BZ) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||