Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > TS and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

In the Test Mode (signal check), a malfunction of the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.
Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to on.

WIRING DIAGRAM


C109400E14


INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).

1.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU TO DLC3)


    C133301E02
  1. Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A25-25 (TS) - E10-12 (TS)
    Always
    Below 1 Ω

  1. Connect the connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (SKID CONTROL ECU TO DLC3)
OK


2.CHECK HARNESS AND CONNECTOR (DLC3 TO BODY GROUND)


    G022987E23
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E10-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 TO BODY GROUND)
OK


3.CHECK HARNESS AND CONNECTOR (DLC3 TO BODY GROUND)


    G022987E24
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E10-12 (TS) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 TO BODY GROUND)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)