FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP OPERATION AND FOR FUEL LEAKS |
Check fuel pump operation.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and push the intelligent tester main switch on.
Select the following menus: Powertrain / Engine / Active Test / Control the Fuel Pump /Speed.
Check for pressure in the fuel inlet tube from the fuel line. Check that sound of fuel flowing in the fuel tank can be heard. If no sound can be heard, check the integration relay, fuel pump, ECM and wiring connector.
Check for fuel leaks.
Check that there are no fuel leaks anywhere on the system after performing maintenance. If there is a fuel leak, repair or replace parts as necessary.
Turn the ignition switch off.
Disconnect the intelligent tester from the DLC3.
| 2. CHECK FUEL PRESSURE |
Using a voltmeter, measure the battery voltage.
Discharge the fuel system pressure (Click here).
Disconnect the cable from the negative (-) battery terminal.
![]() |
Remove the No. 1 fuel pipe clamp from the fuel tube connector.
Disconnect the fuel hose from the fuel main tube.
![]() |
Install SST (pressure gauge) and the fuel tube connector using SST as shown in the illustration.
Wipe up any gasoline.
Reconnect the cable to the negative (-) battery terminal.
Select the following menus: Powertrain / Engine / Active Test / Control the Fuel Pump /Speed.
Measure the fuel pressure.
Disconnect the intelligent tester from the DLC3.
Start the engine.
Measure the fuel pressure at idle.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.
After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove the SST to prevent gasoline from splashing.
Reconnect the fuel main tube (fuel tube connector).
![]() |
Install the No. 1 fuel pipe clamp to the fuel tube connector.
Check for fuel leaks (Step 1).