VEHICLE STABILITY CONTROL SYSTEM > Brake Warning Light does not Come ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if the CAN communication system DTC is output (Click here for LHD, or Click here for RHD).
| Condition | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK BRAKE WARNING LIGHT |
Disconnect the skid control ECU connector.
Turn the ignition switch on (IG).
Check that the BRAKE warning light comes on.
|
| ||||
| NG | |
| 3.INSPECT COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Perform Active Test of the combination meter (meter CPU) using the intelligent tester (Click here).
|
| ||||
| OK | ||
| ||