Home › ENGINE ยท 2AZ-FE › ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > REMOVAL

for Preparation Click here



1. SEPARATE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

HINT:
Click here.



2. SEPARATE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

HINT:
Click here.



3. REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)


    A126932E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A091018
  1. Remove the 8 bolts, rear spacer, drive plate and front spacer.



4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)


    D008941E02
  1. Put matchmarks on the clutch cover assembly and flywheel sub-assembly.

  1. Loosen the 6 bolts one turn at a time until spring tension is released.

  1. Remove the 6 bolts and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.



5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.



6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)


    A126932E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A091020E01
  1. Remove the 8 bolts and flywheel.



7. REMOVE ENGINE REAR OIL SEAL


    A128873E01
  1. Using a knife, cut through the oil seal lip.

  1. Using a screwdriver with its tip taped, pry out the oil seal.

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.