DIFFERENTIAL OIL SEAL > INSTALLATION |
| 1. INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL |
![]() |
Coat a new oil seal lip with MP grease.
Using SST and a hammer, install the oil seal.
| 2. INSTALL TRANSAXLE CASE OIL SEAL |
![]() |
Coat a new oil seal lip with MP grease.
Using SST and a hammer, install the oil seal.
| 3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
| 4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
| 5. INSTALL FRONT WHEELS |
| 6. ADD MANUAL TRANSAXLE OIL |
![]() |
Park the vehicle on a level place.
Remove the filler plug and gasket.
Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the filler plug opening.
Check for oil leakage if the oil level is low.
Install the filler plug and a new gasket.
| 7. INSPECT MANUAL TRANSAXLE OIL |
| 8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
| 9. CHECK ABS SPEED SENSOR SIGNAL |