THEFT DETERRENT SYSTEM (w/ Entry and Start System) > ECU Power Source Circuit |

| 1.CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU) (POWER SOURCE) |
![]() |
Disconnect the ID J/B connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ID-16 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL J/B - BODY GROUND) |
![]() |
Disconnect the IF and IM J/B connectors.
Measure the resistance according to the value(s) in the table below.
| Symbol (Tester Connection) | Condition | Specified Condition |
| IF-10 - Body ground | Always | Below 1 Ω |
| IM-9 - Body ground | Always |
|
| ||||
| OK | ||
| ||