Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/ Entry and Start System)

THEFT DETERRENT SYSTEM (w/ Entry and Start System) > PROBLEM SYMPTOMS TABLE


HINT:
  1. Troubleshooting of the theft deterrent system is based on the premise that the door lock control system and the wireless door lock control system are operating normally. Accordingly, before troubleshooting the theft deterrent system, first make certain that the door lock control system and the wireless door lock control system are operating normally.
  2. Inspect the fuse and relay before investigating the suspected areas shown in the table below.


Theft Deterrent System: 
Symptom
Suspected Area
See page
Theft deterrent system cannot be set
1. Security indicator light circuit
Click here
2. ECU power source circuit
Click here
3. Front door lock assembly
Click here
4. Rear door lock assembly
Click here
5. Door courtesy switch circuit
Click here
6. Luggage compartment door courtesy switch circuit
Click here
7. Engine hood courtesy switch circuit
Click here
Security indicator does not blink when theft deterrent system is set
1. Security indicator light circuit
Click here
2. Replace certification ECU
-
3. If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (Instrument panel J/B)
-
Alarm sounding state cannot be canceled when engine switch is turned on (IG)
Entry and start system (for 2GR-FE)
Click here
Theft deterrent system can be set even when a door is open
1. Door courtesy switch circuit
Click here
2. If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (Instrument panel J/B)
-
Vehicle horns (low pitched, high pitched) do not sound while theft deterrent system is in warning operation
1. Horn circuit
Click here
2. If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (Instrument panel J/B)
-
Hazard warning lights do not flash while theft deterrent system is in warning operation
1. Wire harness
-
2. Turn signal flasher assembly
Click here
3. If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (Instrument panel J/B)
-
Security horn does not sound while theft deterrent system is in warning operation
1. Security horn circuit
Click here
2. Replace certification ECU
-
3. If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (Instrument panel J/B)
-
Hazard warning lights flash even when theft deterrent system is not set
1. Wire harness
-
2. Turn signal flasher assembly
Click here
3. If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (Instrument panel J/B)
-