NAVIGATION SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (CHECK USING INTELLIGENT TESTER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the intelligent tester on.
Enter the following menus: Body / Navigation System / DTC.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (CHECK USING INTELLIGENT TESTER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the intelligent tester on.
Enter the following menus: Body / Navigation System / DTC.
Clear the DTCs.
| START DIAGNOSTIC MODE |
There are 2 methods to start diagnostic mode. Start the mode by using either of them.
![]() |
Method 1
Start the engine.
While pressing and holding the "INFO" switch, operate the light control switch: off → turn on → turn off → turn on → turn off → turn on → turn off.
The diagnostic mode starts and the "Service Menu" screen will be displayed.
Method 2
Start the engine.
![]() |
Press the "DISP" switch.
![]() |
From the display quality adjustment screen, touch the corner of the screen in the following order: upper left → lower left → upper left → lower left → upper left → lower left.
Diagnostic mode starts and the "System Menu" screen will be displayed.
| FINISH DIAGNOSTIC MODE |
Turn the ignition switch off.
| FAILURE DIAGNOSIS |
![]() |
The "Failure Diagnosis" screen is displayed when the "Failure Diagnosis" switch on the "Service Menu" screen is selected.
| SYSTEM CHECK (CHECK USING SYSTEM CHECK MODE SCREEN) |
![]() |
The "System Check Mode" screen is displayed when the "System Check" switch on the "Failure Diagnosis" screen is selected.
| CHECK DTC (CHECK USING SYSTEM CHECK MODE SCREEN) |
![]() |
Read the system check result.
When the result is "EXCH" or "CHEK", select the icon which displays the result, and check and record each DTC displayed on the "Unit Check Mode" screen.
Check the details of the DTC(s) (Click here).
| DTC CLEAR/RECHECK (CLEAR USING SYSTEM CHECK MODE SCREEN) |
![]() |
Clear DTC
Press the "Memory CLR" switch for 3 seconds.
Confirm that the check results are cleared.
![]() |
Recheck
Select the "Recheck" switch.
![]() |
Confirm that all diagnostic codes are "OK" when the check results are displayed. If a code other than "OK" is displayed, troubleshoot again.