Home › SUSPENSION & AXLE › SUSPENSION › REAR NO. 2 SUSPENSION ARM

REAR NO. 2 SUSPENSION ARM > INSTALLATION

for Preparation Click here



1. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM


    C132489E01
  1. Install the rear No. 2 suspension arm (inner side) with the bolt, and temporarily tighten the bolt.

    HINT:
    Ensure that the paint mark faces to the rear of the vehicle.



    C132484
  1. Connect the rear No. 2 suspension arm (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt.

    NOTICE:
    When temporarily tightening the bolt, keep the nut from rotating.



2. STABILIZE SUSPENSION


    C108450E01
  1. Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the installed bolt of the rear suspension No. 1 arm (inner side of vehicle) is horizontally aligned with the center of the rear axle hub.



3. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM


    C132489E01
  1. Fully tighten the bolt.

    Torque:
    100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }



    C132484
  1. Fully tighten the bolt.

    Torque:
    100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }



4. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ HID Headlight System)


    C137785
  1. Install the rear height control sensor sub-assembly RH with the nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



5. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



6. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)


7. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION (w/ HID Headlight System)
(Click here)