LIGHTING SYSTEM > INITIALIZATION |
| HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION |
| 1.PREPARE VEHICLE FOR INITIALIZATION |
Make sure for approximately 10 liters of fuel in the tank.
Unload the trunk and vehicle, ensuring that the spare tire, tools, and jack are in their original positions.
Check that there are no passengers in the vehicle.
Turn off the headlights.
| |||||
| 2.CHECK WARNING LIGHT |
![]() |
Turn the ignition switch to the ON position, and check the headlight beam level control system warning light.
| Condition | Specified Condition |
| The headlight beam level control ECU is replaced with a new one. | Warning light continuously blinks twice at 2 Hz as shown in the illustration. |
| Removal and reinstallation of the headlight beam level control ECU, replacement of the rear height control sensor sub-assembly, removal and reinstallation of the rear height control sensor sub-assembly, or replacement of the suspension, etc. | Warning light comes on for approximately 3 seconds, and then goes off (bulb check function). |
|
| ||||
| |||||
| 3.INITIALIZATION |
![]() |
Connect terminals 4 (CG) and 8 (LVL) of the DLC3 using SST.
Flash the low beam headlights 3 times by turning the light control switch within 20 seconds after connecting the terminals.
![]() |
Check the warning light.
| Condition | Specified Condition |
| The headlight beam level control ECU is replaced with a new one. | Blinks twice at 2 Hz → Blinks 3 times at 2 Hz, and then goes off (refer to illustration 1). |
| Removal and reinstallation of the headlight beam level control ECU, replacement of the rear height control sensor sub-assembly, removal and reinstallation of the rear height control sensor sub-assembly, or replacement of the suspension, etc. | Off → Blinks 3 times at 2 Hz, and then goes off (refer to illustration 2). |
|
| ||||
|
| ||||
|---|---|---|---|---|---|