REAR NO. 2 SUSPENSION ARM > INSTALLATION |
| 1. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM |
![]() |
Install the rear No. 2 suspension arm (inner side) with the bolt, and temporarily tighten the bolt.
![]() |
Connect the rear No. 2 suspension arm (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt.
| 2. STABILIZE SUSPENSION |
![]() |
Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the installed bolt of the rear suspension No. 1 arm (inner side of vehicle) is horizontally aligned with the center of the rear axle hub.
| 3. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM |
![]() |
Fully tighten the bolt.
![]() |
Fully tighten the bolt.
| 4. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ HID Headlight System) |
![]() |
Install the rear height control sensor sub-assembly RH with the nut.
| 5. INSTALL REAR WHEEL |
| 6. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |
| 7. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION (w/ HID Headlight System) |