LIGHTING SYSTEM > Ignition Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select the items below in the DATA LIST, and read the display on the intelligent tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| ACC SW | Ignition switch ACC signal / ON or OFF | ON: Ignition switch ON or ACC OFF: Ignition switch off | - |
| IG SW | Ignition switch IG signal / ON or OFF | ON: Ignition switch ON or ACC OFF: Ignition switch off | - |
|
| ||||
| NG | |
| 2.INSPECT ACC RELAY |
![]() |
Remove the ACC relay from the instrument panel J/B assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| Below 1 Ω (When battery voltage is applied to terminals 1 and 2) |
|
| ||||
| OK | |
| 3.INSPECT NO. 1 IGNITION RELAY |
![]() |
Remove the No. 1 ignition relay from the instrument panel J/B assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| Below 1 Ω (When battery voltage is applied to terminals 1 and 2) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL J/B ASSEMBLY - BATTERY AND GROUND) |
![]() |
Disconnect the IA instrument panel J/B assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IA-1 - Body ground | Always | 10 to 14 V |
![]() |
Disconnect the IF instrument panel J/B assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IF-10 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL J/B ASSEMBLY - IGNITION SWITCH) |
![]() |
Disconnect the E23 ignition switch connector.
Disconnect the II instrument panel J/B assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| II-3 - E23-2 (ACC) | Always | Below 1 Ω |
| II-4 - E23-4 (AM1) | Always | Below 1 Ω |
| II-9 - E23-1 (IG1) | Always | Below 1 Ω |
| II-3 - Body ground | Always | 10 kΩ or higher |
| II-4 - Body ground | Always | 10 kΩ or higher |
| II-9 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.INSPECT IGNITION SWITCH |
Inspect the ignition switch (Click here)
|
| ||||
| OK | ||
| ||