LIGHTING SYSTEM > Door Courtesy Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select the items below in the DATA LIST, and read the display on the intelligent tester.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| D DOR CTY SW | Driver side door courtesy switch signal / ON or OFF | ON: Driver side door is open OFF: Driver side door is closed | - |
| P DOR CTY SW | Passenger side door courtesy switch signal / ON or OFF | ON: Passenger side door is open OFF: Passenger side door is closed | - |
| RR DOR CTY SW | Rear RH door courtesy switch signal / ON or OFF | ON: Rear right door is open OFF: Rear right door is closed | - |
| Rr DOR CTY SW | Rear LH door courtesy switch signal / ON or OFF | ON: Rear left door is open OFF: Rear right door is closed | - |
|
| ||||
| NG | |
| 2.INSPECT DOOR COURTESY SWITCH |
Inspect the front door courtesy switch (Click here).
Inspect the rear door courtesy switch (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - DOOR COURTESY SWITCH) |
![]() |
Check the harness and connector between the main body ECU and door courtesy switches (passenger side and rear RH).
Disconnect the E6 main body ECU connector.
Disconnect the O10 rear RH door courtesy switch connector.
Disconnect the O6 or M6 passenger side door courtesy switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E6-5 (RCTY) - O10-1 (Rear RH) | Always | Below 1 Ω |
| E6-21 (PCTY) - O6-1 (*1) | Always | Below 1 Ω |
| E6-21 (PCTY) - M6-1 (*2) | Always | Below 1 Ω |
| E6-5 (RCTY) - Body ground | Always | 10 kΩ or higher |
| E6-21 (PCTY) - Body ground | Always | 10 kΩ or higher |
![]() |
Check the harness and connector between the instrument panel J/B assembly and rear LH door courtesy switch.
Disconnect the IO instrument panel J/B assembly connector.
Disconnect the N13 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IO-7 (LCTY) - N13-1 (Rear LH) | Always | Below 1 Ω |
| IO-7 (LCTY) - Body ground | Always | 10 kΩ or higher |
![]() |
Check the harness and connector between the main body ECU and driver side door courtesy switch.
Disconnect the E7 main body ECU connector.
Disconnect the M6 or O6 driver side door courtesy switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-24 (DCTY) - M6-1 (*1) | Always | Below 1 Ω |
| E7-24 (DCTY) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||