AUDIO AND VISUAL SYSTEM > Steering Pad Switch Circuit |

| 1.INSPECT RADIO RECEIVER |
![]() |
Disconnect the radio receiver connector F8.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| SW1 - SWG | No switch is pushed | Approx. 100 kΩ |
| SW1 - SWG | SEEK+ switch: push | 0 to 2.5 Ω |
| SW1 - SWG | SEEK- switch: push | Approx. 0.3 kΩ |
| SW1 - SWG | VOL+ switch: push | Approx. 1 kΩ |
| SW1 - SWG | VOL- switch: push | Approx. 3.1 kΩ |
| SW2 - SWG | No switch is pushed | Approx. 100 kΩ |
| SW2 - SWG | MODE switch: push | 0 to 2.5 Ω |
|
| ||||
| OK | ||
| ||
| 2.INSPECT STEERING PAD SWITCH ASSEMBLY |
Disconnect the steering pad switch assembly connector.
Measure the resistance according to the values in the table below.

| Tester connection | Condition | Specified condition |
| AU1 - EAU | No switch is pushed | Approx. 100 kΩ |
| AU1 - EAU | SEEK+ switch: push | 0 to 2.5 Ω |
| AU1 - EAU | SEEK- switch: push | Approx. 0.3 kΩ |
| AU1 - EAU | VOL+ switch: push | Approx. 1 kΩ |
| AU1 - EAU | VOL- switch: push | Approx. 3.1 kΩ |
| AU2 - EAU | No switch is pushed | Approx. 100 kΩ |
| AU2 - EAU | MODE switch: push | 0 to 2.5 Ω |
|
| ||||
| OK | |
| 3.INSPECT SPIRAL CABLE |
![]() |
Disconnect the steering pad switch and spiral cable connectors.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Spiral Cable Position | Specified condition |
| EAU - EAU | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| AU1 - AU1 | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right | ||
| AU2 - AU2 | Center | Below 1 Ω |
| 2.5 rotations to the left | ||
| 2.5 rotations to the right |
|
| ||||
| OK | ||
| ||