METER / GAUGE SYSTEM > Speedometer Malfunction |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication DTC is output (Click herefor LHD, Click here for RHD).
| Result | Proceed to |
| CAN communication DTC is not output. | A |
| CAN communication DTC is output. | B (Click herefor LHD, Click here for RHD) |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Enter the following menus: Diagnosis / OBD/MOBD / Combination Meter / Active Test.
Check the operation by referring to the values in the table below.
| Tester Display | Test Part | Control Range | Normal Condition |
| Speed Meter Operation | Speedometer | 0, 40, (24), 80 (48), 120 (72), 160 (96), 200 (120) km/h (mph) | - |
|
| ||||
| OK | |
| 3.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Enter the following menus: Diagnosis / OBD/MOBD / Combination Meter / Data List.
Check the values by referring to the values in the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed Meter | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) | Almost same as actual speed (When driving) | If data received from the skid control ECU exceeds the range that can be displayed on the meter, the meter continues to display the maximum value of the range. |
|
| ||||
| OK | ||
| ||
| 4.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Enter the following menus: Diagnosis / OBD/MOBD / ABS/TRAC/VSC / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR/FL/RR/RL Wheel Speed | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Almost same as actual speed (When driving) | - |
|
| ||||
| OK | |
| 5.REPLACE SKID CONTROL ECU |
Replace the skid control ECU with a new or a normal one.
|
| ||||
| OK | ||
| ||