TRANSMISSION CONTROL CABLE > INSTALLATION |
| 1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Install the No. 2 shift cable grommet retainer to the transmission control cable assembly.
Install the control cable assembly through the floor hole.
Install the control cable assembly with the 2 bolts.
![]() |
Connect the ends of the 2 cables and install the 2 washers and 2 clips.
Install 2 new clips to the control cable bracket.
| 2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Connect the control cable to the shift lever retainer.
![]() |
Connect the end of the shift cable to the shift lever assembly with the clip.
Connect the end of the select cable to the shift lever assembly with a new clip.
| 3. INSTALL CENTER AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the battery negative (-) cable is disconnected.
![]() |
Install the center airbag sensor assembly with the 3 bolts.
Check that there is no looseness in the installation parts of the center airbag sensor assembly.
Connect the holder (with connectors).
Check that the water-proof sheet is properly set.
| 4. INSTALL AIR CONDITIONER UNIT ASSEMBLY |
| 5. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY |
| 6. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY |
![]() |
Engage the 3 claws and 5 clips to install the upper console rear panel sub-assembly.
| 7. INSTALL UPPER CONSOLE PANEL |
![]() |
Engage the 2 claws and the 5 clips to install the upper console panel as shown in the illustration.
| 8. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() |
Engage the 2 clips and install the No. 2 instrument cluster finish panel garnish.
| 9. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() |
Engage the 2 clips and install the No. 1 instrument cluster finish panel garnish.
| 10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Install the shift lever knob sub-assembly.
| 11. INSTALL BATTERY |
Install the battery and battery tray.
![]() |
Install the battery clamp with the bolt and nut.
| 12. INSTALL AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Install the air cleaner case with the 3 bolts.
Connect the hose clamp.
| 13. INSTALL AIR CLEANER CAP SUB-ASSEMBLY |
Install the air cleaner filter element onto the air cleaner case.
![]() |
Insert the hinges. Install the air cleaner cap sub-assembly with the 2 bolts.
![]() |
Align the matchmarks of the No. 1 air cleaner hose and throttle body, and then connect the air cleaner hose No. 1 to the throttle body and unfasten the No. 1 air cleaner hose clamp.
![]() |
Connect the No. 2 ventilation hose to the air cleaner hose.
![]() |
Connect the purge line hose to the clamp (*1).
Connect the 2 purge VSV vacuum hoses (*2).
Connect the purge VSV connector (*3).
Connect the mass air flow meter connector (*4).
| 14. INSTALL AIR CLEANER INLET ASSEMBLY |
![]() |
Install the air cleaner inlet with the 2 bolts.
| 15. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Install the engine cover with the 2 nuts.
| 16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |