DIFFERENTIAL OIL SEAL > INSTALLATION |
| 1. INSTALL TRANSAXLE HOUSING OIL SEAL |
![]() |
Using SST and a hammer, install a new oil seal.
Coat the lip of the oil seal with MP grease.
| 2. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL |
![]() |
Using SST and a hammer, install a new oil seal.
Coat the lip of the oil seal with MP grease.
| 3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Coat the spline of the inboard joint shaft assembly with ATF.
Align the shaft splines and install the drive shaft assembly LH with a brass bar and hammer.
| 4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
![]() |
Coat the spline of the inboard joint shaft assembly with ATF.
Install the front drive shaft the assembly RH.
Using a screwdriver, install a new bearing bracket hole snap ring.
Install a new bolt.
| 5. INSTALL FRONT AXLE ASSEMBLY LH |
![]() |
Align the matchmarks and install the front drive shaft assembly to the front axle hub sub-assembly.
| 6. INSTALL FRONT AXLE ASSEMBLY RH |
| 7. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM LH |
![]() |
Install the lower ball joint to the front suspension lower No. 1 arm with the bolt and 2 nuts.
| 8. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM RH |
| 9. INSTALL TIE ROD ASSEMBLY LH |
Install the tie rod end sub-assembly to the steering knuckle with the nut.
Install a new cotter pin.
| 10. INSTALL TIE ROD ASSEMBLY RH |
| 11. INSTALL FRONT SPEED SENSOR LH |
![]() |
Install the front speed sensor to the steering knuckle with the bolt.
![]() |
Install the flexible hose and the speed sensor to the shock absorber with the bolt and set the sensor clip on the knuckle.
| 12. INSTALL FRONT SPEED SENSOR RH |
| 13. INSTALL FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Install the stabilizer link assembly with the nut.
| 14. INSTALL FRONT STABILIZER LINK ASSEMBLY RH |
| 15. INSTALL FRONT AXLE HUB NUT LH |
Clean the threaded parts on the drive shaft and front axle hub nut using a non-residue solvent.
![]() |
Using a socket wrench (30 mm), install a new axle hub nut.
Using a chisel and hammer, stake the front axle hub nut.
| 16. INSTALL FRONT AXLE HUB NUT RH |
| 17. INSTALL FRONT WHEEL |
| 18. ADD AUTOMATIC TRANSAXLE FLUID |
| 19. INSPECT AUTOMATIC TRANSAXLE FLUID |
![]() |
Park the vehicle on a level surface and set the parking brake.
With the engine idling and the brake pedal depressed, move the shift lever to all positions from P to L. Then return it to P.
Pull out the dipstick and wipe it clean.
Push it back fully into the pipe.
Pull it out again and check that the fluid level is within the HOT range. If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add proper amount of new fluid and recheck the fluid level.
| 20. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
| 21. CHECK ABS SPEED SENSOR SIGNAL |