POWER STEERING SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT DRIVE BELT |
![]() |
Visually check the drive belt for excessive wear, frayed cords, etc.
If any defect is found, replace the drive belt.
| 2. CHECK POWER STEERING FLUID LEVEL |
Keep the vehicle level.
![]() |
With the engine stopped, check the fluid level in the fluid reservoir.
If necessary, add fluid.
Start the engine and run it at idle.
Turn the steering wheel from lock to lock several times to raise fluid temperature.
![]() |
Check for foaming or emulsification.
If foaming or emulsification is identified, bleed the power steering system .
![]() |
With the engine idling, measure the fluid level in the fluid reservoir.
Stop the engine.
Wait a few minutes and remeasure the fluid level in the fluid reservoir.
Check the fluid level.
| 3. INSPECT STEERING FLUID PRESSURE |
Disconnect the pressure feed tube assembly from the vane pump assembly (Click here for 2AZ-FE, Click here for 2GR-FE).
![]() |
Connect SST as shown in the illustration.
Bleed the power steering system .
Start the engine and run it at idle.
Turn the steering wheel from lock to lock several times to raise fluid temperature.
![]() |
With the engine idling, close the valve of the SST and observe the reading on the SST.
![]() |
With the engine idling, open the valve fully.
Measure the fluid pressure at engine speeds of 1,000 rpm and 3,000 rpm.
![]() |
With the engine idling and the valve fully opened, turn the steering wheel left or right to the full lock position. Observe the reading on the SST.
Disconnect the SST.
Connect the pressure feed tube assembly to the vane pump assembly (Click here for 2AZ-FE, Click here for 2GR-FE).
Bleed the power steering system .
| 4. CHECK STEERING EFFORT |
Stop the vehicle on a level, paved surface and turn the wheels straight ahead.
Disconnect the negative (-) battery cable from the battery.
Remove the steering pad (Click here).
Connect the negative (-) battery cable to the battery.
Using a torque wrench, check if the steering wheel set nut is properly tightened.
Start the engine and run it at idle.
![]() |
Turn the steering wheel 90 degrees to the right and check steering effort (torque) while turning the wheel. Check the opposite direction in the same manner.
Disconnect the negative (-) battery cable from the battery.
Torque the steering wheel set nut.
Install the steering pad (Click here).
Connect the negative (-) battery cable to the battery.
Clear the DTCs (Click here).
Inspect the airbag warning light (Click here).