Home › ENGINE ยท 2GR-FE › IGNITION › IGNITION COIL

IGNITION COIL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap sub-assembly from the radiator assembly.



  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs, then drain the coolant.


    A128117E02

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



3. REMOVE WINDSHIELD WIPER LINK ASSEMBLY
(Click here)


4. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY


    A136272
  1. Remove the 4 bolts, 4 nuts and cowl top panel outer sub-assembly.



5. REMOVE V-BANK COVER SUB-ASSEMBLY


    A132968
  1. Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A135704
  1. Disconnect the 3 vacuum hoses.



    A135705E01
  1. Disconnect the mass air flow meter connector (*1).

  1. Disconnect the No. 2 ventilation hose (*2).

  1. Disconnect the hose band (*3).



    A135706
  1. Disconnect the 3 bands, and remove the air cleaner cap sub-assembly.



7. REMOVE INTAKE AIR SURGE TANK ASSEMBLY


    A129464E03
  1. Disconnect the 2 water by-pass hoses from the throttle with motor body assembly. (*1)

  1. Disconnect the vapor feed hose. (*2)

  1. Disconnect the throttle with motor body assembly connector and clamp. (*3)



    A129465E08
  1. Disconnect the No. 1 ventilation hose. (*4)

  1. Disconnect the union to check valve hose. (*5)



    A129466
  1. Remove the bolt and vacuum hose clamp.



    A129467
  1. Disconnect the connector.



    A129468E06
  1. Using a 5 mm socket hexagon wrench, remove the 4 bolts. (*1)

  1. Remove the 2 nuts, 2 bolts and intake air surge tank. (*2)

  1. Remove the gasket from the intake air surge tank.



8. REMOVE NO. 1 SURGE TANK STAY


    A136114
  1. Remove the bolt and disconnect the harness clamp.



    A134967
  1. Remove the bolt and No. 1 surge tank stay.



9. REMOVE IGNITION COIL ASSEMBLY


    A134966E01
  1. Disconnect the 6 ignition coil connectors.

  1. Remove the 6 bolts and 6 ignition coils.