Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › PLASMACLUSTER

PLASMACLUSTER > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)

NOTICE:
After the ignition switch is turned off, the navigation receiver assembly (HDD navigation system) records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.



2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


3. DISCONNECT BATTERY NEGATIVE TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the terminal to prevent the airbag from deploying. (Click here)



4. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
  1. Remove the instrument panel safety pad assembly (Click here).



5. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT


    B134016E02
  1. Remove the screw <F> and the side No. 1 defroster nozzle duct.



6. REMOVE NO. 1 HEATER TO REGISTER DUCT


    B134019E02
  1. Remove the 3 screws <F> and the No. 1 heater to register duct.



7. REMOVE PLASMACLUSTER


    E128542
  1. Remove the 2 screws and plasmacluster.