FRONT DRIVE SHAFT > INSTALLATION |
| 1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Coat the spline of the inboard joint shaft assembly with ATF.
Align the shaft splines and install the drive shaft assembly LH with a brass bar and hammer.
| 2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
![]() |
Coat the spline of the inboard joint shaft assembly with ATF.
Install the front drive shaft the assembly RH.
Using a screwdriver, install a new bearing bracket hole snap ring.
Install a new bolt.
| 3. INSTALL FRONT AXLE ASSEMBLY |
![]() |
Align the matchmarks and install the front drive shaft assembly to the front axle hub sub-assembly.
| 4. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM |
![]() |
Install the lower ball joint to the front suspension lower No. 1 arm with the bolt and 2 nuts.
| 5. INSTALL TIE ROD END SUB-ASSEMBLY |
Install the tie rod end sub-assembly to the steering knuckle with the nut.
Install a new cotter pin.
| 6. INSTALL FRONT SPEED SENSOR |
![]() |
Install the front speed sensor to the steering knuckle with the bolt.
![]() |
Install the flexible hose and the speed sensor to the shock absorber with the bolt and set the sensor clip on the knuckle.
| 7. INSTALL FRONT STABILIZER LINK ASSEMBLY |
![]() |
Install the stabilizer link assembly with the nut.
| 8. INSTALL FRONT AXLE HUB NUT |
Clean the threaded parts on the drive shaft and front axle hub nut using a non-residue solvent.
![]() |
Using a socket wrench (30 mm), install a new axle hub nut.
Using a chisel and hammer, stake the front axle hub nut.
| 9. INSTALL FRONT WHEEL |
| 10. ADD AUTOMATIC TRANSAXLE FLUID (for Automatic Transaxle) |
for 2GR-FE: Click here
for 2AZ-FE: Click here
| 11. ADD MANUAL TRANSAXLE OIL (for Manual Transaxle) |
![]() |
Park the vehicle on a level place.
Remove the filler plug and gasket.
Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the filler plug opening.
Check for oil leakage if the oil level is low.
Install the filler plug and a new gasket.
| 12. INSPECT AUTOMATIC TRANSAXLE FLUID (for 2AZ-FE, Automatic Transaxle) |
![]() |
Park the vehicle on a level surface and set the parking brake.
With the engine idling and the brake pedal depressed, move the shift lever to all positions from P to L. Then return it to P.
Pull out the dipstick and wipe it clean.
Push it back fully into the pipe.
Pull it out again and check that the fluid level is within the HOT range. If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add proper amount of new fluid and recheck the fluid level.
| 13. INSPECT MANUAL TRANSAXLE OIL (for Manual Transaxle) |
![]() |
Stop the vehicle on a level surface.
Remove the transmission filler plug and gasket.
Check that the oil surface is within 5 mm (0.20 in.) of the bottom of the transmission filler plug opening.
Check for oil leakage if the oil level is low.
Install the transmission filler plug and a new gasket.
| 14. ADJUST FRONT WHEEL ALIGNMENT |
| 15. CHECK ABS SPEED SENSOR SIGNAL |
ABS: Click here
VSC: Click here