DTC C1241/41 Low Battery Positive Voltage or Abnormally High Battery Positive Voltage |
| DTC No. | DTC Detecting Condition | Trouble Area |
| C1241/41 | With vehicle speed more than 6 km/h (4 mph), when any of the following is detected:
|
|

| 1.INSPECT FUSE (ECU-IG NO. 2 FUSE) |
![]() |
Remove the ECU-IG No. 2 fuse from the instrument panel J/B.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| ECU-IG No. 2 fuse | Below 1 Ω (Continuity) |
Install the fuse.
|
| ||||
| OK | |
| 2.INSPECT BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU CONNECTOR (IG1 TERMINAL VOLTAGE) |
![]() |
Disconnect the skid control ECU connector.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A25-18 (IG1) - Body ground | Ignition switch on | 10 to 14 V |
|
| ||||
| OK | |
| 4.INSPECT SKID CONTROL ECU CONNECTOR (GND TERMINAL CONTINUITY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| A25-4 (GND1) - Body ground | Below 1 Ω |
| A25-1 (GND2) - Body ground | Below 1 Ω |
Connect the connector.
|
| ||||
| OK | |
| 5.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch to the ON position.
Check if the same DTC is recorded (Click here).
| Condition | Proceed to |
| DTC (C1241/41) is output | A |
| DTC (C1241/41) is output (When troubleshooting in accordance with the PROBLEM SYMPTOMS TABLE) | B |
| DTC (C1241/41) is not output (When troubleshooting in accordance with the DTC CHART) | C |
|
| ||||
|
| ||||
| A | ||
| ||