DTC C0278/11 Open or Short Circuit in ABS Solenoid Relay Circuit |
| DTC No. | DTC Detecting Condition | Trouble Area |
| C0278/11 | When any of the following is detected:
|
|

| 1.INSPECT FUSIBLE LINK (ABS NO. 2 FUSE) |
![]() |
Remove the fusible link from the engine room R/B.
Check if the fusible link is melted.
Install the fusible link to the engine room R/B with the nut.
|
| ||||
| OK | |
| 2.INSPECT SKID CONTROL ECU CONNECTOR (+BS CIRCUIT) |
![]() |
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A25-3 (+BS) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU CONNECTOR (GND TERMINAL CONTINUITY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| A25-4 (GND1) - Body ground | Below 1 Ω |
| A25-1 (GND2) - Body ground | Below 1 Ω |
Connect the connector.
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Condition | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||