Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/ Entry and Start System)

THEFT DETERRENT SYSTEM (w/ Entry and Start System) > Engine Hood Courtesy Switch Circuit


DESCRIPTION

The engine hood courtesy switch is installed together with the hood lock. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.

WIRING DIAGRAM


B144359E05


INSPECTION PROCEDURE

1.CHECK CERTIFICATION ECU (VOLTAGE)


    B144361E01
  1. Disconnect the A5 switch connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A5-2 - Body ground
    Always
    11 to 14 V



NG
Go to step 4
OK


2.INSPECT ENGINE HOOD COURTESY SWITCH


    B144360E01
  1. Remove the courtesy switch from the hood lock.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    A5-1 - A5-2
    Free (ON)
    Below 1 Ω
    Pushed (OFF)
    10 kΩ or higher



NG
REPLACE HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH) (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND)


    B144361E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A5-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

4.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE HOOD COURTESY SWITCH)


    B144362E02
  1. Disconnect the E75 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E75-24 (HSW) - A5-2
    Always
    Below 1 Ω
    E75-24 (HSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)