Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/ Entry and Start System)

THEFT DETERRENT SYSTEM (w/ Entry and Start System) > Security Indicator Light Circuit


DESCRIPTION

Even when the theft deterrent system is in the disarmed state, the security indicator blinks due to a signal output from the immobiliser system. The security indicator blinks continuously due to a continuous signal received from the immobiliser system while it is set or when the theft deterrent system is in the armed state.
The certification ECU causes the security indicator to come on only during the arming preparation state and alarm sounding state.

WIRING DIAGRAM


B139455E07


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Press the intelligent tester main switch on.

  1. Select the item below in the Active Test and then check that the indicator operates.

    Smart (Certification ECU): 
    Tester Display
    Test Details
    Diagnostic Note
    Security Indicator
    Security Indicator ON/OFF
    -

    OK:
    The security indicator light flashes or goes off correctly when operating it through the intelligent tester.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - CERTIFICATION ECU)


    B228049E01
  1. Disconnect the E74 ECU connector.

  1. Disconnect the F3 clock connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-2 (IND) - F3-8 (LP)
    Always
    Below 1 Ω
    E74-2 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - BODY GROUND)


    E128063E13
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F3-19 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT CLOCK ASSEMBLY


    B139454E04
  1. Reconnect the F3 clock connector.

  1. Apply battery voltage between the terminals of the indicator, and check the lighting condition of the security indicator.

    Standard :
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal F3-8 (LP)
    Battery negative (-) → Terminal F3-19 (GND1)
    Security indicator comes on

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
    2. Voltage of more than 12 V will damage the security indicator.
    3. If the voltage is too low, the security indicator will not come on.



NG
REPLACE CLOCK ASSEMBLY (Click here)
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)