DTC U0100 Lost Communication with ECM / PCM "A" |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0100 |
| TCM |

| 1.CHECK ECU TERMINAL VOLTAGE (+B AND E1 TERMINALS) |
![]() |
Disconnect the TCM connector.
Turn the ignition switch on.
Measure the voltage of the TCM connector.
| Tester Connection | Specified Condition |
| C56-18 (+B) - C56-8 (E1) | 9 to 14 V |
Turn the ignition switch off.
Measure the resistance of the TCM connector.
| Tester Connection | Specified Condition |
| C56-8 (E1) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TCM - ECM) |
![]() |
Disconnect the C56 TCM connector.
Disconnect the C58*1 or C55*2 ECM connector.
*1: for RHD
*2: for LHD
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C56-6 (CAN+) - C58-2*1 (CAN+) | Below 1 Ω |
| C56-6 (CAN+) - C55-2*2 (CAN+) | Below 1 Ω |
| C56-7 (CAN-) - C58-1*1 (CAN-) | Below 1 Ω |
| C56-7 (CAN-) - C55-1*2 (CAN-) | Below 1 Ω |
| C56-6 (CAN+) or C58-2*1 (CAN+) - Body ground | 1 MΩ or more |
| C56-6 (CAN+) or C55-2*2 (CAN+) - Body ground | 1 MΩ or more |
| C56-7 (CAN-) or C58-1*1 (CAN-) - Body ground | 1 MΩ or more |
| C56-7 (CAN-) or C55-1*2 (CAN-) - Body ground | 1 MΩ or more |
|
| ||||
| OK | |
| 3.CHECK IF DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Clear the DTC.
Replace the TCM.
Start the engine.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0100 | A |
| No DTC | B |
|
| ||||
| A | ||
| ||