Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse shift position signal from the park/neutral position switch assembly.

WIRING DIAGRAM


E150789E23


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E168562E14
  1. Disconnect the F25 connector from the navigation receiver assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F25-5 (REV) - Body ground
    Ignition switch ON
    Shift lever in R
    11 to 14 V
    F25-5 (REV) - Body ground
    Ignition switch ON
    Shift lever in any position except R
    Below 1 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Navigation Receiver Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - PARK/NEUTRAL POSITION SWITCH)


    E150782E17
  1. Disconnect the C1 connector from the park/neutral position switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F25-5 (REV) - C1-1 (RL)*3
    Always
    Below 1 Ω
    F25-5 (REV) - C1-2 (RL)*4
    Always
    Below 1 Ω
    F25-5 (REV) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Navigation Receiver Assembly)
    *2
    Front view of wire harness connector
    (to Park/Neutral Position Switch Assembly)
    *3
    for 2AZ-FE
    *4
    for 2GR-FE



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (NAVIGATION RECEIVER - PARK/NEUTRAL POSITION SWITCH)
OK


3.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    E153722E12
  1. Disconnect the C1 connector from the park/neutral position switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (RL) - 2 (RB)*2
    1 (RB) - 2 (RL)*3
    Shift lever in R
    Below 1 Ω
    1 (RL) - 2 (RB)*2
    1 (RB) - 2 (RL)*3
    Shift lever in any position except R
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Park/Neutral Position Switch Assembly)
    *2
    for 2AZ-FE
    *3
    for 2GR-FE

Result:
Result
Proceed to
OK
A
NG (for 2AZ-FE)
B
NG (for 2GR-FE)
C



B
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (for U250E) (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (for U660E) (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR (PARK/NEUTRAL POSITION SWITCH ASSEMBLY - BATTERY)