Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > CD cannot be Inserted / Played or CD is Ejected Right After Insertion

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IF A PROPER CD IS INSERTED
  1. Make sure that the CD is an audio CD or a CD with an MP3 or WMA file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

    OK:
    CD is normal.

    HINT:
    1. Translucent or uniquely-shaped CDs cannot be played.
    2. Commercial audio CDs can be played.
    3. CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
    4. MP3 and WMA files on CD-ROMs, CD-Rs and CD-RWs can be played.
    5. For details on playable CDs, refer to the Owner's Manual.



NG
CD IS FAULTY
OK


2.CHECK THAT CD IS INSERTED PROPERLY
  1. Check whether or not the CD is inserted upside down.

    OK:
    CD is properly inserted.



NG
SET CD PROPERLY
OK


3.CLEANING CD


    I100201E04
  1. Disc cleaning

    1. If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

      NOTICE:
      Do not use a conventional record cleaner or anti-static preservative.



NG
Go to step 4
OK

END (CD WAS DIRTY) 

4.REPLACE CD WITH ANOTHER AND RECHECK
  1. Replace the CD with a normal one and check that the same trouble does not occur.

    OK:
    The same trouble does not occur.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

CD WAS FAULTY