Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch and information about the GPS antenna, and then adjusts the vehicle position on the navigation display.

WIRING DIAGRAM


E176572E04


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E168562E14
  1. Disconnect the navigation receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F25-5 (REV) - Body ground
    Ignition switch ON
    Shift lever in R
    11 to 14 V
    F25-5 (REV) - Body ground
    Ignition switch ON
    Shift lever in any position except R
    Below 1 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Navigation Receiver Assembly)



NG
Go to step 2
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)


    E168562E14
  1. Disconnect the navigation receiver assembly connector.



    E176475E07
  1. Disconnect the park/neutral position switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F25-5 (REV) - C1-1 (RL)*3, C1-2 (RL)*4
    Always
    Below 1 Ω
    F25-5 (REV) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Navigation Receiver Assembly)
    *2
    Front view of wire harness connector
    (to Park/Neutral Position Switch)
    *3
    for 2AZ-FE
    *4
    for 2GR-FE



OK
REPAIR OR REPLACE HARNESS OR CONNECTOR
NG


3.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - BATTERY)


    E176475E08
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    C1-2 (RB)*2, C1-1 (RB)*3 - Body ground
    Ignition switch ON
    11 to 14 V

    Result 
    Result
    Proceed to
    OK
    A
    NG (for U660E)
    B
    NG (for U250E)
    C
    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Park/Neutral Position Switch)
    *2
    for 2AZ-FE
    *3
    for 2GR-FE



B
REPLACE PARK/NEUTRAL POSITION SWITCH (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR