BRAKE PEDAL > INSTALLATION |
| 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (for LHD) |
![]() |
Temporarily install the brake pedal support assembly with the bolt.
![]() |
Temporarily install the No. 1 brake pedal support plate with 2 bolts (A) and bolt (B).
Install the brake booster assembly (Click here).
![]() |
Fully tighten the bolt.
![]() |
Fully tighten 2 bolts (A) and bolt (B).
![]() |
Engage the 2 clamps and connect the stop light switch connector.
| 2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (for RHD) |
![]() |
Temporarily install the brake pedal support assembly with the bolt and install the clamp.
![]() |
Temporarily install the No. 1 brake pedal support plate with 2 bolts (A) and bolt (B).
Install the brake booster assembly. (Click here)
![]() |
Fully tighten the bolt.
![]() |
Fully tighten 2 bolts (A) and bolt (B).
![]() |
Connect the stop light switch connector.
Install the accelerator pedal with the 2 bolts.
![]() |
Connect the 2 connectors.
| 3. INSTALL BRAKE BOOSTER ASSEMBLY |
| 4. INSTALL ACCELERATOR PEDAL ROD (for RHD) |
![]() |
Install the accelerator pedal rod with the 2 bolts.
Connect the accelerator pedal position sensor connector.
| 5. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY |
![]() |
Install the headlight leveling ECU assembly with the bolt.
Connect the connector.
| 6. INSTALL COMBINATION METER ASSEMBLY |
![]() |
Connect each connector.
Install the combination meter assembly with the 4 screws <E>.
| 7. INSTALL INSTRUMENT CLUSTER FINISH PANEL NO.1 |
![]() |
Engage the guide and the 4 claws.
Install the instrument cluster finish panel with the 2 clips.
| 8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL |
![]() |
Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.
| 9. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY |
Connect each connector.
![]() |
Engage the 3 claws and 2 clips to install the No. 1 instrument panel sub-assembly.
| 10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH |
![]() |
Install the air hose and connect the connector.
Engage the 2 claws and the DLC3.
Engage the claw and the 4 clips.
Instal the lower instrument panel finish panel LH with the screw <B> and bolt <A>.
| 11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY |
![]() |
Engage the 2 clips.
Install the cowl side trim sub-assembly LH with the cowl side trim clip.
| 12. INSTALL FRONT DOOR SCUFF PLATE |
![]() |
Engage the 7 claws and 3 clips, then install the front door scuff plate LH.