Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.



    A106634E02
  1. Install the crankshaft position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the crankshaft position sensor connector.



2. INSTALL COOLER COMPRESSOR ASSEMBLY

HINT:
(Click here)



3. INSTALL GENERATOR ASSEMBLY

HINT:
(Click here )