Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

DTC    U0073/94    Control Module Communication Bus OFF

for Preparation Click here


DESCRIPTION

  1. The skid control ECU receives the signal sent from the ECM via the CAN communication system.
  2. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.

DTC No.
DTC Detecting Condition
Trouble Area
U0073/94
When any of the following is detected:
  1. The skid control ECU cannot send a signal (30 cycles).
  2. The condition that bus OFF state occurs for 300 msec.
  1. Wire harness (CANL, CANH circuit)
  2. Brake actuator assembly (Skid control ECU)

INSPECTION PROCEDURE

Proceed to CAN communication system troubleshooting (Click here for LHD, Click here for RHD).

HINT:
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.