POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) |
| 1.PERFORM INITIALIZATION (APPLICABLE LOCATION) |
Initialize the power window regulator motor assembly (applicable location) (Click here).
| NEXT | |
| 2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (APPLICABLE LOCATION)) |
Check that all door power windows move when the auto up/down function of the power window regulator master switch assembly and power window regulator switch assembly (for front passenger, rear LH and rear RH sides) is operated (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION) |
Remove the window regulator.
Install the window glass onto the door glass run.
Check if the door window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it up by hand.
| Result | Proceed to |
| NG | A |
| OK (Driver side power window) | B |
| OK (Front passenger side power window) | C |
| OK (Rear LH side power window) | D |
| OK (Rear RH side power window) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||