DTC U0129 Lost Communication with Skid Control ECU |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| U0129 | When either of following conditions detected:
|
|

| 1.CONFIRM DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Clear the stored DTCs by selecting the following menu items on the tester: Diagnosis / OBD / MOBD / Combination Meter / DTC Info / Clear Codes.
Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.
Stop the vehicle.
Check for DTCs (Click herefor LHD, Click here) for RHD).
| Result | Proceed to |
| DTC output | A (Click herefor LHD, Click here for RHD) |
| DTC not output | B |
|
| ||||
| A | ||
| ||