DTC P1660 VSV for AICVS Circuit |

| DTC No. | Detection Condition | Trouble Area |
| P1660 | The following conditions are met simultaneously for 0.5 seconds or more (2 trip detection logic):
|
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSV FOR AICV) |
![]() |
Turn the ignition switch to the ON position and turn the intelligent tester ON.
Select the following menu items: Powertrain / Engine / Active Test / Active the VSV for ACIS and operate the VSV for AICV.
Check the operation of the VSV when the VSV is operated by the intelligent tester.
| Tester Operation | Specified Condition |
| VSV is ON | Air from port E flows out through port F |
| VSV is OFF | Air from port E flows out through the air filter |
|
| ||||
| NG | |
| 2.CHECK VSV ASSEMBLY (FOR ACIV) |
Inspect the intake air control valve assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (VSV FOR AICV - EFI MAIN RELAY) |
![]() |
Check the wire harness between the VSV for AICV connector and the ECM connector.
Disconnect the A53 VSV for AICV connector.
Disconnect the A24 (RHD) or A55 (LHD) ECM connector.
Measure the resistance between the terminals of the wire harness side connectors and body ground.
| Tester Connection | Specified Condition |
| VSV for AICV (A53-2) - ACIV (A24-4) | Below 1 Ω |
| Tester Connection | Specified Condition |
| VSV for AICV (A53-2) - ACIV (A55-4) | Below 1 Ω |
| Tester Connection | Specified Condition |
| VSV for AICV (A53-2) or ACIV (A24-4) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| VSV for AICV (A53-2) or ACIV (A55-4) - Body ground | 10 kΩ or higher |
Check the EFI No. 3 fuse.
Remove the EFI No. 3 fuse from the engine room R/ B.
Measure the resistance of the EFI No. 3 fuse.
Reinstall the EFI No. 3 fuse.
Check the wire harness between the VSV for AICV and the EFI relay.
Remove the engine room junction block from the engine room R/B.
Measure the resistance between the terminals of the wire harness side connectors.
| Tester Connection | Specified Condition |
| VSV for AICV (A53-1) - 1E-6 | Below 1 Ω |
Reconnect the VSV for AICV connector.
Reinstall the engine room junction block.
|
| ||||
| OK | |
| 4.INSPECT VACUUM TANK |
Inspect the vacuum tank .
|
| ||||
| OK | ||
| ||