DTC B1297 Clearance Sonar ECU Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1297 | No communication from clearance warning ECU |
|

| 1.CHECK DTC |
Check for DTCs.
| Result | Proceed to |
| B2326 is not output | A |
| B2326 is output | B |
|
| ||||
| A | |
| 2.CHECK CAN MS BUS WIRE (CLEARANCE WARNING ECU) |
Turn the ignition switch off.
![]() |
Disconnect connector O28 from the clearance warning ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| O28-3 (R1) - O28-5 (R2) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| O28-17 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| O28-15 (IG) - Body ground | Ignition switch on | 10 to 14 V |
|
| ||||
| OK | ||
| ||