Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Indicator Circuit

for Preparation Click here


DESCRIPTION

When the clearance sonar main switch is turned on, an ON signal is sent to the clearance warning ECU and the indicator on the switch comes on.

WIRING DIAGRAM


E183789E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE SONAR MAIN SWITCH - BODY GROUND)
  1. Remove the clearance sonar main switch assembly.



    E168460E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E71-7 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CLEARANCE SONAR MAIN SWITCH ASSEMBLY (Click here)