TOYOTA PARKING ASSIST-SENSOR SYSTEM > Clearance Warning Buzzer Circuit |

| 1.CHECK CLEARANCE WARNING BUZZER |
Check the buzzer which does not sound.
| Result | Proceed to |
| Clearance warning buzzer (for Corner Sensors) | A |
| Clearance warning buzzer (for Back Sensors) | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING BUZZER) |
![]() |
Disconnect the S17 connector from the clearance warning ECU.
Disconnect the E67 connector from the clearance warning buzzer (for corner sensors).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S17-6 (BGM1) - E67-2 (BK) | Always | Below 1 Ω |
| S17-6 (BGM1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING BUZZER - CLEARANCE SONAR MAIN SWITCH) |
![]() |
Disconnect the E67 connector from the clearance warning buzzer (for corner sensors).
Disconnect the E66 connector from the clearance sonar main switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E67-1 (FR) - E66-1 | Always | Below 1 Ω |
| E67-1 (FR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT CLEARANCE WARNING BUZZER |
Replace the clearance warning buzzer (for corner sensors) (Click here).
Check the operation of the toyota parking assist-sensor system (Click here).
| Result | Proceed to |
| Buzzer sound | A |
| Buzzer does not sound | B |
|
| ||||
| A | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING BUZZER) |
![]() |
Disconnect the S17 connector from the clearance warning ECU.
Disconnect the E65 connector from the clearance warning buzzer (for back sensors).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S17-22 (BGM2) - E65-1 (BD) | Always | Below 1 Ω |
| S17-22 (BGM2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING BUZZER - CLEARANCE SONAR MAIN SWITCH) |
![]() |
Disconnect the E65 connector from the clearance warning buzzer (for back sensors).
Disconnect the E66 connector from the clearance sonar main switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E65-2 (RR) - E66-1 | Always | Below 1 Ω |
| E65-2 (RR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 7.INSPECT CLEARANCE WARNING BUZZER |
![]() |
Remove the clearance warning buzzer (for back sensors) (Click here).
Apply battery voltage and check the operation of the clearance warning buzzer, as shown in the table below.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2 | Operating sound occurs |
|
| ||||
| OK | ||
| ||