Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Clearance Warning Buzzer Circuit

for Preparation Click here


DESCRIPTION

The clearance warning buzzer sounds using pulse signals sent from the clearance warning ECU assembly. The buzzer sounds to alert the driver and the buzzer frequency changes depending on the distance to an obstacle.

WIRING DIAGRAM


E183790E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Clearance Sonar / Active Test.

  1. Check that the buzzer operates by performing the Active Test.

    Clearance Sonar 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Clearance warning buzzer
    Operate or Stop
    Confirm that the vehicle is stopped and the ignition switch is ON

    OK:
    The clearance warning buzzer sounds.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING BUZZER)


    E149963E08
  1. Disconnect the O28 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    O28-10 (BBZ) - F31-1
    Always
    Below 1 Ω
    O28-11 (EF) - F31-2
    Below 1 Ω
    O28-10 (BBZ) - Body ground
    10 kΩ or higher
    O28-11 (EF) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE CLEARANCE WARNING BUZZER
  1. Replace the clearance warning buzzer with a new or normally functioning one (Click here).


NEXT


4.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Clearance Sonar / Active Test.

  1. Check that the buzzer operates by performing the Active Test.

    Clearance Sonar 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Clearance warning buzzer
    Operate or Stop
    Confirm that the vehicle is stopped and the engine switch is on (IG)

    OK:
    The clearance warning buzzer sounds.



NG
REPLACE CLEARANCE WARNING ECU (Click here)
OK

END (CLEARANCE WARNING BUZZER WAS DEFECTIVE)