TOYOTA PARKING ASSIST-SENSOR SYSTEM > Clearance Warning Buzzer Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Clearance Sonar / Active Test.
Check that the buzzer operates by performing the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Buzzer | Clearance warning buzzer | Operate or Stop | Confirm that the vehicle is stopped and the ignition switch is ON |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - CLEARANCE WARNING BUZZER) |
![]() |
Disconnect the O28 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O28-10 (BBZ) - F31-1 | Always | Below 1 Ω |
| O28-11 (EF) - F31-2 | Below 1 Ω | |
| O28-10 (BBZ) - Body ground | 10 kΩ or higher | |
| O28-11 (EF) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE CLEARANCE WARNING BUZZER |
Replace the clearance warning buzzer with a new or normally functioning one (Click here).
| NEXT | |
| 4.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Clearance Sonar / Active Test.
Check that the buzzer operates by performing the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Buzzer | Clearance warning buzzer | Operate or Stop | Confirm that the vehicle is stopped and the engine switch is on (IG) |
|
| ||||
| OK | ||
| ||