DTC B2324 Rear Door LH ECU Communication Stop |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2324 | No communication between power window regulator motor assembly (for rear LH side) and main body ECU (instrument panel junction block) for more than 10 seconds. |
|

| 1.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MOTOR - BATTERY AND BODY GROUND) |
![]() |
Disconnect the K7 motor connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K7-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| K7-2 (B) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - POWER WINDOW REGULATOR MOTOR ASSEMBLY) |
![]() |
Disconnect the E8 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E8-10 (LIN2) - K7-9 (LIN) | Always | Below 1 Ω |
| E8-10 (LIN2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for REAR LH SIDE) |
Replace the power window regulator motor assembly (for rear LH side) (Click here).
| NEXT | |
| 4.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||