TOYOTA PARKING ASSIST-SENSOR SYSTEM > Back Sonar Sensor RH Circuit |

| 1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - REAR RIGHT CENTER SENSOR) |
![]() |
Disconnect the S17 connector from the clearance warning ECU.
Disconnect the j2 connector from the No. 2 ultrasonic sensor (rear right center sensor).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S17-11 (E3) - j2-1 (E) | Always | Below 1 Ω |
| S17-12 (S3) - j2-2 (S) | Always | Below 1 Ω |
| S17-11 (E3) - Body ground | Always | 10 kΩ or higher |
| S17-12 (S3) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT NO. 2 ULTRASONIC SENSOR (REAR RIGHT CENTER SENSOR) |
![]() |
Remove the No. 2 ultrasonic sensor (rear right center sensor) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (E) - 2 (S) | Always | 11.8 to 15.8 kΩ |
|
| ||||
| OK | ||
| ||