Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Back Sonar Sensor LH Circuit

for Preparation Click here


DESCRIPTION

The No. 2 ultrasonic sensor (rear left center sensor) is installed on the rear bumper.
The clearance warning ECU detects obstacles based on signals received from the rear left center sensor. If the rear left center sensor circuit has an open, short or other malfunction, it will not function normally.

WIRING DIAGRAM


E159947E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - REAR LEFT CENTER SENSOR)


    E159925E01
  1. Disconnect the S17 connector from the clearance warning ECU.

  1. Disconnect the j1 connector from the No. 2 ultrasonic sensor (rear left center sensor).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S17-27 (E4) - j1-1 (E)
    Always
    Below 1 Ω
    S17-28 (S4) - j1-2 (S)
    Always
    Below 1 Ω
    S17-27 (E4) - Body ground
    Always
    10 kΩ or higher
    S17-28 (S4) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NO. 2 ULTRASONIC SENSOR (REAR LEFT CENTER SENSOR)


    E159932E01
  1. Remove the No. 2 ultrasonic sensor (rear left center sensor) (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (E) - 2 (S)
    Always
    11.8 to 15.8 kΩ



NG
REPLACE NO. 2 ULTRASONIC SENSOR (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)